DMT Presenter Control Betriebsanweisung PDF herunterladen (Seite 46)

S1 User Handbook

ADVANCED CONFIGURATIONS

To Congure a GPIO please refer to the GPI: mode in the Serial Command Interface Section.

General Purpose Outputs

Each GPO can be congured to generate an output from up to 10 dierent internal controls.

For example, a GPO could be congured to generate a global talkback function. The GPO

would be setup so that:

* When microphones 2, 3 and 4 are all not live, generate a GPO continuous output

The GPO could then be linked back into one of the GPI’s with the Input Congured to:

* Force PFL on Mics 2,3 & 4

* Enable Auto CUE/PFL Guest

This would allow the guests to freely talk to each other until one of their mics goes live.

Options / Conguration

The Output can be congured to operate in several dierent ways aswell:

* Momentary / Continuous GPO

* Active High / Low GPO

Tally Back

In addition to the telco remote mode, the channel can be congured to show the state of

the external equipment. Once the channel has been armed, the channel will ash green,

until a GPI signal (tally back) has been received back to conrm that the external equipment

is now online. This will then allow the channel to be opened. If the external tally is lost (ie a

tbu goes oine), the mixer will wait for 1 second before muting the channel & returning to

the green ashing state.

In telco mode, it is possible to use the telco mode to set up an external link and then

switch over to use the other input on that particular channel. If the tally is lost whilst still

monitoring the other side of the input channel, the on button shall ash orange at a 25%

duty cycle, to show that the external link has been lost.

To re-setup the link, the user must switch to the channel with the telco mode, turn the

channel o, & then turn it back on. When the tally is received from the external equipment,

the orange/green ashing will stop.

Automation Tally

An automation tally can be used as a visual indication to the presenter that something

is happening or about to happen. When an auto tally is congured on a playout system

channel for example, the auto tally could be used to indicate to the presenter that the

playout track is about to end. When the GPI becomes active the ON button will ash green.

To congure all GPIO and tally modes, please refer to the SCi section

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 79 80

Keine Kommentare

DMT Presenter Control Betriebsanweisung Seite 46