DMT Presenter Control Betriebsanweisung Seite 29

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 80
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 28
S1 User Handbook
17
2
USER GUIDE
USER GUIDE
Monitor and Headphone Controls
Level controls
Each monitor output has it’s own
level control which operates ona
range of zero to ten. Zero represents
fully attenuated and ten represents
+6dB in the guest and presenter
headphones or unity in the monitor.
Auto CUE/PFL
When the green illuminated AUTO
CUE/PFL button is selected, any
input channels selected to CUE/
PFL are automatically routed to the
appropriate out. The selection of
this button can be locked if required.
Split CUE / PFL
The presenter headphones have the additional facility of SPLIT CUE/PFL. When this button is
selected, the monitor source will be heard in mono in the left headphone, and CUE/PFL will
be heard in mono in the right headphone. The button is illuminated yellow when selected.
The selection of this button can be locked if required.
Talkback
When pressed, the Talkback button will route talkback from the talkback microphone to
the guest headphones. The talkback signal can be congured to either cut or mix into the
headphones.
While the talkback button is pressed, the switch is illuminated RED and the talkback is
active. The buttons work with both a momentary and latched operation. If held down, the
selection is cancelled when released, otherwise the button is alternate action.
If necessary it is also possible to permanently route the talkback audio to the talkback
connector on the back panel irrespective of whether TALKBACK or CUE/PFL & T/B have
been pressed. This may be required if an additional talkback routing panel is used to route
talkback to multiple locations.
Mute
The red mute LED will illuminate whenever a mic channel, which has been designated
to Control Room mute, goes live. This will mute the control room monitors to prevent
feedback. Two pairs of contacts on the remote connector of the PGM output channel will
close whenever the mute function is active. These can be used to remotely illuminate “Mic
Live lights.
Fig 2-26: Level controls
Seitenansicht 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 79 80

Kommentare zu diesen Handbüchern

Keine Kommentare